Cub Cadet Clutch Pressure Plates for Older Mowers or Garden Tractor Pulling

Posted by Julian Stahl on

Cub Cadet Mowers or Garden Tractors for Pulling: Why should I replace the stock pressure plates?
The stock pressure plates might not need to be replaced. Stock pressure plates
are made with a thinner design and when used for pulling may result in warping.
Check the stock Cub Cadet  plates to ensure that they are completely flat. If they are not completely flat, they can be machined flat again or replaced with MWSC pressure plates which are made from one piece billet metal making them less likely to warp.  We make pressure plates that fit the standard size disc (4.5") This would be the only one that would work on an  Cub Cadet riding mowers # 52127. The 4 puck clutch (5.0") and the 5 puck clutch (5.5") are to be used for Pulling Tractors, garden size with different disc and driver. mwsc.co  for complete catalog. Also available are the Spiral pins for the clutches and replacement Drive Shafts.  See our website to order.

 


Share this post



← Older Post Newer Post →


Leave a comment