Tech Article

How to break in a flat tappet cam

Posted by Cathy Stahl on

Here's how to break in a flat tappet cam. This is critical for your cam to survive.

Read more →

Is My Tractor Pulling Tractor Covered for......

Posted by Cathy Stahl on

Is My Tractor Pulling Tractor covered for…                                 A couple of years ago, Julian & I were at Keystone Nationals in Harrisburg, PA and pulled up the weather radar for back home, it was nothing but bright red spots and warning boxes over our hometown of DeWitt and surrounding areas. After the radar map cleared over our area, I started calling family to see if everyone and everything was ok.  The answer was yes, until about 2 hours later; and I was told my nephew’s farm and buildings were hit by a tornado. Everyone was fine, but the destruction was...

Read more →

Required Oil Brands for Use with MWSC Flat Tappet Camshaft & Lifters

Posted by Cathy Stahl on

Wear protection reference categories are:  *** Over 90,000 psi = OUTSTANDING protection  *** 75,000 to 90,000 psi = GOOD protection  *** 60,000 to 75,000 psi = MODEST protection  *** Below 60,000 psi = UNDESIREABLE The higher the psi number, the better the wear protection. 1. 10W30 Lucas Racing Only synthetic = 106,505 psi zinc = 2642 ppm phos = 3489 ppm ZDDP= 3000 ppm NOTE: This oil is suitable for short term racing use only, and is not suitable for street use. 2. 10W30 Valvoline NSL (Not Street Legal) Conventional Racing Oil = 103,846 psi zinc = 1669 ppm phos...

Read more →

Welcome to the new site!

Posted by Julian Stahl on

We are still working on adding more parts and information to the site. Be sure to check out the Facebook store as well! Since this is all new, please be patient with us if there are any issues. If you see something that you think is an error please reach out to us and let us know! Thanks for all your support throughout all the years of tractor pulling! We strive to bring you the best parts when you need them.

Read more →