Tech Article

Cub Cadet Pulling Tractor: What size rear rims go with what size tires?

Posted by Cathy Stahl on

For a Cub Cadet pulling tractor 12x12 with 4/8 offset and 12x 12 with 6/6 offset rims both can be used with 26x12x12 tires.  12x10 rims with a 4/6 offset are to be used with the 23x10.50x12 tires. The 12x12 with a 4/8  offset sets the tire out from the tractor the 6/6 offset tucks the tires under the tractor more.  The 12x14 rims DO NOT WORK WITH 26X12X12 TIRES.The idea of a bigger footprint sounds great but does not work, don't waste your time, energy or $.

Read more →

John Deere & Wheel Horses have raised center wheel hubs What do I do?

Posted by Cathy Stahl on

John Deere and Wheel Horses have raised center hub on rear wheels, how do I fit Douglas Wheels on them? MWSC has a 5/16 wheel spacer part # 51374 to space the wheel out, you can also turn the hub down. Real Wheels have a center hole that measures 3 5/16. Real Wheels part # 53002 1210, # 53000 1266 or # 52998 1248.  The 1266 rims & 1248 rims are to be used for 26x12x12 tires, the 1210 rims are to be used with 23x10.50 x 12 tires

Read more →

How to break in a flat tappet cam

Posted by Cathy Stahl on

Here's how to break in a flat tappet cam. This is critical for your cam to survive.

Read more →

Is My Tractor Pulling Tractor Covered for......

Posted by Cathy Stahl on

Is My Tractor Pulling Tractor covered for…                                 A couple of years ago, Julian & I were at Keystone Nationals in Harrisburg, PA and pulled up the weather radar for back home, it was nothing but bright red spots and warning boxes over our hometown of DeWitt and surrounding areas. After the radar map cleared over our area, I started calling family to see if everyone and everything was ok.  The answer was yes, until about 2 hours later; and I was told my nephew’s farm and buildings were hit by a tornado. Everyone was fine, but the destruction was...

Read more →

Required Oil Brands for Use with MWSC Flat Tappet Camshaft & Lifters for a Kohler Command motor for Pulling

Posted by Cathy Stahl on

Wear protection reference categories are:  *** Over 90,000 psi = OUTSTANDING protection  *** 75,000 to 90,000 psi = GOOD protection  *** 60,000 to 75,000 psi = MODEST protection  *** Below 60,000 psi = UNDESIREABLE The higher the psi number, the better the wear protection. 1. 10W30 Lucas Racing Only synthetic = 106,505 psi zinc = 2642 ppm phos = 3489 ppm ZDDP= 3000 ppm NOTE: This oil is suitable for short term racing use only, and is not suitable for street use. 2. 10W30 Valvoline NSL (Not Street Legal) Conventional Racing Oil = 103,846 psi zinc = 1669 ppm phos...

Read more →