Tech Articles

Fuel / ExhaustCan you use gas or alcohol in the plastic fuel tank?Yes, either fuel is suitable. Is the fuel pump you offer gas or alcohol? Either, the pump we sell is suitable for both.What size pipe goes with the XF12 (Exhaust Flange for a 12 HP)?The 1-⅜” ID (inside diameter) pipe. Part # 51610 for PlainWhat size pipe goes on the XF16 (Exhaust Flange for a 16 HP)?The 1-⅝” ID (inside diameter) pipe. Part # 51609 for PlainIgnitionWhat else do I need to make the Electronic Ignition (EI) work on my tractor?You need a 3 OHM coil. We sell...

What makes the Midwest Super Cub (MWSC) gas pedal different?The Midwest Super Cub (MWSC) gas pedal features a machined slot with a bronze bushing allowing the pedal to move smoothly. For example, our MWSC gas pedal does not have a sticky spot when depressing the pedal.How does the rear wheel fit over the hub on John Deere and Wheel Horse tractors?The hub can be turned down, or use our 5/16” wheel spacers (page 11 in our 2019 catalog).Can my Cub Cadet have 1” spindles?Yes, some of the 1000 Series Cub Cadet and some John Deere tractors have 1” spindles. The...

What fluid should be used in the transmission?We recommend Hy-Trans fluid by IH or Farmall, or Hy-Gard by John Deere. These fluids have a rust inhibitor in them for when the tractor is stored in an unheated garage, or trailer, where the variation of temperatures creates condensation. For a pulling tractor use only 2 quarts.Is locking the shifter with a rigid lock necessary?Yes, a solid lock is necessary. Ratchet straps and hands are just not strong enough.Is the MWSC Shifter a direct replacement for the stock shifter?Yes, and the MWSC shifters have a built-in shifter lock. Simply put the tractor...

Can I build my own clutch through you guys?Yes, we make it easy for you. Come up with a custom 6 digit part number by selecting the components you desire in your clutch. Simply follow these steps: The first number will always be 8 For the second number, put 1 for a complete clutch without a 6 pin driver, and 2 for a complete clutch with a 6 pin driver In the third number you’ll specify your desired disc: 1 for Kevlar Disc, 2 for 3 puck, 3 for 4 puck, and 4 for 5 puck In the fourth number...

Are the Commands V-twin metric or SAE measurements?The Command V-Twin is an all metric engine, with exception to the valve lifters. The lifters are 0.842” in diameter, which is the same diameter as the Small Block Chevy (SBC). The Command lifter spacer is wider than the SBC.  What is the stroke on the Command crank?All commands have the same stroke 2.640” (67 mm), with exception to the 30 HP (Model CH750) which has a stroke of 2.716” (69 mm). What is done to these engine blocks?The 18-22 HP engines have a 3.032” (77 mm) bore, the 23 HP a 3.150” (80...